Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instructions
protection
1. SAFETY
Follow manufacturers guidance for the specific vehicle being worked on for wheel removal and replacement.
9
Use tool only as specified by the manufacturer.
9
Seek professional assistance to change vehicle's wheel if necessary.
9
Before commencing any work, undertake a risk assessment. Ensure that a responsible person is aware of the work about to be
9
undertaken.
Inspect the equipment before each use. DO NOT use if it shows signs of damage.
9
Securely chock wheels in contact with the ground. Before jacking and placing the stands, apply vehicle handbrake (put automatics in
9
'Park').
Take care when manoeuvring heavy objects as fingers could become trapped.
9
No alterations or modifications shall be made to this product.
9
Once vehicle is supported, ensure that the vehicle and stands are stable before starting work. Ensure that it is not possible for the
9
vehicle to move before commencing any work.
8
DO NOT allow children or animals in the vicinity of a supported vehicle.
8
DO NOT push or twist the vehicle/load whilst it is supported.
DO NOT use this product for any other purpose than that for which it is designed.
8
NOTE: Only wheels using M12 and M14 threaded fasteners can be used with this kit.
NOTE: Maximum wheel weight 35Kg.
2. INTRODUCTION
Manufactured from high quality stainless steel. Polypropylene and TPV rubber soft grip handle for comfort and control. Supplied with four
CNC machined stainless steel adaptor pegs complete with storage holder. Designed to assist with the lifting and locating of road wheels on to
vehicle hubs and intended to be used where there is no access to a vehicle lift such as by the roadside or off the workshop floor. Significantly
reduces lifting effort whilst improving body posture. Intended for use on alloy or steel wheels up to 35kg. Suitable for most cars, light goods
vehicles, motor homes and caravans.
3. SPECIFICATION AND CONTENTS
Model No.:................................................................ AK7500
Lever x 1 (with moulded handle)
M12 x 1 OFF, M14 x 1 Off Adaptor pegs (for nut fixings)
M12 x 1 OFF, M14 x 1 Off Adaptor pegs (for bolt fixings)
M12 Nut adaptor
M12 Bolt adaptor
4. OPERATION
Familiarise yourself with the safety guidelines (Section 1) in this document.
4.1.
Follow the vehicle manufacturers guidelines to raise the vehicle using a jack so the wheel is approximately 5cm or 2" clear of the
4.2.
ground. Remove the road wheel.
Select the required mounting peg based on type and size of fixing for your wheel. The peg should fit snugly either in the hub bolt
4.3.
© Jack Sealey Limited
WHEEL FITTING & ALIGNMENT TOOL
MODEL NO:
Wear protective
Wear safety
gloves
footwear
M14 Nut adaptor
M14 Bolt adaptor
Original Language Version
AK7500
Wear protective
clothing
AK7500 Issue 1 20/05/22