Sealey AK467D Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear protective
instruction gloves
manual
1. SAFETY
i
Replace damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Keep the drainer clean, dry and in good condition for best and safest performance.
9
Wear appropriate protective clothing and eye protection.
9
If it is necessary to raise the vehicle ensure that it is properly supported. If the vehicle has been raised with a jack, axle stands must be
9
put in place before working under the vehicle.
Remove the oil drainer and other tools and equipment from underneath the vehicle before lowering it again.
9
Use drainer in a suitable work area. Keep area clean and tidy, and free from unrelated materials and ensure that there is adequate
9
lighting.
The work area should have a flat and level surface capable of supporting the weight of the drainer and it's contents.
9
DO NOT position the drainer in such a way that it becomes a hazard to others in the work area.
8
Ensure that the floor is not slippery and wear non-slip shoes.
9
Keep children and unauthorised persons away from the work area.
9
Dispose of waste liquids in accordance with local authority regulations.
9
WARNING! DO NOT allow uncontrolled discharge of fluids which would pollute the environment.
‰
DO NOT use the drainer in wet or damp areas or where condensation is present.
8
DO NOT use the drainer near open flames or other sources of heat.
8
WARNING! If draining the oil whilst hot, take precautions to prevent against burns, particularly hands, wrists and arms.
‰
2. INTRODUCTION
Low level drainers suitable for use on the forecourt and workshop floor. Steel fabricated unit with a capacity of 64ltr. Fitted with gravity
drain tap for manual discharge. Model No. AK467DXP fitted with rotary pump and 2.5m hose for faster discharge. Fully portable with
two castors, two fixed wheels and handle for manoeuvring around the workshop.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AK467D . . . . . . . . . . . . . . . . . . . AK467DXP
Capacity:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64ltr . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64ltr
Maximum Pan Height: . . . . . . . . . . . . . . . . . . . . . . . 285mm. . . . . . . . . . . . . . . . . . . . . . . .285mm
Gravity Feed: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
Gravity Discharge: . . . . . . . . . . . . . . . . . . . . . . . . . . Yes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
Pump Discharge: . . . . . . . . . . . . . . . . . . . . . . . . . . . No . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
Nett weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14.77kg . . . . . . . . . . . . . . . . . . . . . . 20.97kg
4. ASSEMBLY
4.1. CASTOR WHEELS (fig.1). Bolt a castor wheel to each of the projecting brackets either side of the handle mount using the M12 nuts and
washers provided.
4.2. FIXED WHEELS (fig.2). Insert the special axle bolts through each wheel so that the wheel is running on the roller bearing. Mount each
wheel by pushing the axle bolt through each of the tubular axle mounts welded to the back, bottom edge of the casing. Secure each axle
bolt with the M12 lock nuts provided.
DO NOT over tighten.
8
© Jack Sealey Limited
LOW LEVEL OIL DRAINERS 64LTR
MODELS:
Wear eye Wear protective
protection clothing
fig.1
Original Language Version
AK467D, AK467DXP
fig.2
AK467D, AK467DXP Issue 3 (H,3,F) 26/02/19