Tuning In A Station; Presetting Stations - JVC CA-MXS6MDR Instructions Manual

Tuning in a Station

1
Press FM/AM.
The unit automatically turns on and tunes in the
previously tuned station (either FM or AM–MW/LW).
• Each time you press the button, the band alternates
between FM and AM.
2
Tune into a station.
On the remote control:
Press and hold ¡ (¢) or 1 (4) until the
station frequencies start changing in the main
display.
• ¡ (¢) : to increase the frequencies.
• 1 (4) : to decrease the frequencies.
On the unit:
Push and hold the joy control upward ( ) or
downward ( ) until the station frequencies start
changing in the main display.
• Upward ( ): to increase the frequencies.
• Downward ( ): to decrease the frequencies.
The unit starts searching stations and stops when a
station of sufficient signal strength is tuned in (the
TUNED indicator lights).
• If an FM program is broadcast in stereo, the STEREO
indicator also lights.
To stop during searching, press ¡ (¢) or 1 (4)
(or push the joy control again on the unit).
When you repeatedly press ¡
(or push the joy control upward or downward on
the unit)
The frequency changes step by step.
When an FM stereo broadcast is hard to
receive or noisy
You can use the menu to improve FM reception.
See "FM Reception Mode Setting" on page 62.
¡ ¡ ¢ ¢ 1 1 4 4
¡ ¡ (¢ ¢ ) or 1 ¢ 1 (4 1 4 ) 4
– 16 –

Presetting Stations

You can preset 30 FM and 15 AM (MW/LW) stations —
using either automatic presetting method or manual
presetting method.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
To preset stations automatically — Automatic
Presetting
On the remote control ONLY:
You need to preset stations separately for the FM and AM
bands.
1
Press FM/AM to select the band.
2
Press and hold AUTO PRESET until "A. PRESET"
appears in the main display for about 2 seconds.
Local stations with strong signals are searched and
stored in memory automatically.
When automatic preset is over, the station stored in
preset number 1 is received.
3
Repeat steps 1 and 2 to store stations of the other
band.
When you cannot store stations you want
automatically
Stations with weak signals cannot be detected with this automatic
presetting method. To store such a station, use the manual
presetting method on page 17.
Continued