Roche Accu-Check Glucotrend 2 Instructions

Glucotrend
Basic Meter Instructions

Performing a test

•
Ensure you have set the time and date on your Meter before
testing. Please refer to "Entering Settings" in the User's Guide.
•
Turn the meter on by pressing centre button
•
To check that all display elements are correct, wait for all three
digits 888 to completely appear on the screen
•
Check that the code on the screen matches the code number
printed on the test strip vial. Remember to change the code
calibration chip every time you open a new vial of test strips.
•
Remove test strip from the vial. Replace vial cap.
•
Insert the strip in the test slot in the direction shown by arrows until
it clicks into place.
•
The 3 digit code number will disappear.
•
After approximately one second, a small blood drop symbol flashes
on display indicating readiness to apply blood to test strip.
•
After just a few seconds, you will hear a beep tone and a rotating
box will indicate that the reading is in progress. Result will show in
15 seconds.
•
Results will be saved automatically, if time and date are set
correctly.

Coding the Glucotrend

•
Remove the calibration coding chip from the test strip pack
•
The coding chip slot is level with the bottom of the display window.
•
Turn the chip so that the flat side with the code number inscribed
on it, is facing upwards.
•
Carefully insert the coding chip in the slot and press it in as far as it
will go.
•
If the monitor is off, switch it on.
•
The bottom line of the display will show the time and date and a
three digit code will be shown in the centre of the display. To the
left of the screen, a test strip symbol and CODE will be flashing. A
red dot flashes in the test-strip guide.
•
Make sure that code on the monitor is the same as the code
number on the pack of test strips.
®
2
®
2