Connecting Signals - NI CB-2162 User Manual

Before attaching any cables or accessories, install the digital waveform
Caution
generator/analyzer. Refer to the Getting Started Guide that shipped with your device for
instructions on installing the module.

Connecting Signals

Before powering down the digital waveform generator/analyzer module, remove
Caution
power from the prototyping area of the NI CB-2162. NI is not liable for any damage
resulting from improper signal connections.
NI CB-2162 User Guide
2. Attach either end of the cable assembly to the DDC connector of the
digital waveform generator/analyzer module and secure the cable with
the captive screws on the cable connector.
3. Attach the other end of the cable assembly to the DDC connector of the
NI CB-2162 and secure them together with the captive screws on the
cable connector.
Each DIO, PFI, and clock channel of the digital waveform
generator/analyzer connects to a corresponding pin on the NI CB-2162.
Refer to Figure 1 for the location of these pins on the NI CB-2162.
6 ni.com