Remote Control; Installing The Batteries For The Remote Control; Operating With The Remote Control - Sanyo FWSB405F A Owner's Manual

Remote control

Installing the batteries for the remote control

Install 2 AAA (1.5V) batteries matching the polarity indicated inside battery compartment of the remote control.
1 2
NOTE(S)
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, Li-ion, etc) batteries.
• Do not mix old and new batteries.
• Always remove batteries from the remote control if they are dead or if the remote control is not to be used for an
extended period of time. This will prevent battery acid from leaking into the battery compartment.

Operating with the remote control

1
2
3
4
5
6
7
EN
• The maximum operable ranges from the unit are as follows.
3
– Line of sight:
– Either side of the center: approx. 16 feet (5m) within 30°
– Above:
– Below:
8
9
10
11
12
– 7 –
approx. 23 feet (7m)
approx. 16 feet (5m) within 15°
approx. 10 feet (3m) within 30°
Buttons
Press to turn on the unit, or to switch the unit
into standby mode.
1
( To completely turn off the unit, you must
unplug the AC power cord.)
Press to switch to the standard preset sound.
2
Press to switch to the preset sound for music.
3
Press to mute the sound and press again to
4
unmute the sound.
Press to select optical input of the connected
5
device to this soundbar.
Press to select line input of a connected device
6
to this soundbar.
Press to select auxiliary input of a connected
7
device to this soundbar.
Press to adjust volume up / down on the
8
soundbar.
Press to switch to the preset sound for a
9
movie.
Press to switch to the preset sound for news
10
scene.
Press to select Bluetooth signal of a connected
11
device to this soundbar.
Press to disconnect the currently connected
Bluetooth compatible device and start pairing
mode to establish a new connection to another
Bluetooth compatible device.
12
If no Bluetooth compatible device is connected
within 2 minutes, press this button to restart
pairing mode. Pairing mode can only be started
when Bluetooth is selected.
Description