Software; Ip Connection; Ip Connection Procedure; Installing The Software - Panasonic AK-HRP1010G Operating Instructions Manual

Software

IP connection

Setup Software is software to configure the settings for connecting the unit and a studio camera from a personal computer.
It allows you to configure the settings while checking each item in a list.
When configuring settings from a personal computer using ROP Setup Software, please pay attention to the following points.
NOTE
Do not perform an operation on the unit.
Do not start up ROP Setup Software on another personal computer on the same network.
Do not use Easy IP Setup Software at the same time.

IP connection procedure

This section describes how to configure the unit and CCU using the software.
For the system configuration when using IP connections, see the following page.
"System Connection Configuration" (see page 17)
Connection flow

1. Installing the software

Install ROP Setup Software on a personal computer.
"Installing the software" (see page 131)
2. Equipment connections
Connect the unit to the CCU via a switching hub (100base-TX) with LAN cables.
Be sure to connect the devices via a switching hub because the personal computer for configuring the IP settings needs
to be connected. Use a switching hub with PoE support because the unit can be powered by PoE.
"IP connection" (see page 18)
3. Connecting and setting the personal computer
Use a LAN cable to connect the computer to a switching hub (100base-TX), and configure the computer's net-
work settings.
Configure the network settings of the personal computer so that it is in the same segment as the unit and CCUs.
"Connecting and setting the personal computer" (see page 132)
4. Device IP address configuration
Operate the menus of the device to be connected to set the IP address.
For details on the menu operation, refer to the operating instructions of the corresponding devices.
"Setting the IP addresses of the devices" (see page 132)
5. Configuring various settings of the ROP
Use ROP Setup Software to configure the connection settings.
6. Start operation
Installing the software
This section describes how to install ROP Setup Software.
You can obtain the software from the support desk on the following website.
https://pro-av.panasonic.net/
1. Download the zip file for ROP Setup Software from the support desk on the website.
2. Double-click the downloaded zip file and extract the software.
Be sure to read "Readme.txt" before installing the software.
3. Double-click "HRP1010Tool.exe" in the "Setup Software" folder to start ROP Setup Software.
- 131 -
Software