Canon Perfect Binder-F1 User Manual page 39

2
2
2-18
Replenishing Glue
Open the glue container's lid and its inner lid and replenish
the glue.
Fill the glue container with glue so it is even and level and does not go over the
limit mark.
CAUTION

Do not allow glue to get into the binder's mechanical parts through the
gaps in the binder. If glue gets into the binder's mechanical parts it could
cause a malfunction.

Do not put anything other than glue into the glue container. If something
other than glue gets into the glue container it could cause a fire or
malfunction.

Do not add so much glue that it goes over the limit mark. Doing so may
prevent the glue container from closing or cause glue to spill inside the
mechanical parts of the binder.

When the glue is filled up, it may be difficult to open the glue container. If
this happens, open the glue container slowly again and again. Opening it
too hard might cause a malfunction.
IMPORTANT

Use the supplied scoop to replenish the glue. Do not use the supplied scoop except
for replenishing the glue. Also, store the scoop in a safe place for future use.

Do not use glue that has fallen on the floor because it might have dust or dirt in it.