Pasta Dough Recipe; Making Pasta Sheets; Dismantling - Silvercrest SKV 1200 A1 Operating Instructions Manual

Pasta dough recipe

You can process your usual pasta dough with the
pasta attachment or use the food processor to
produce the following pasta dough:
1) Add 340 g of semolina (durum wheat), 140 ml
and 10 ml of oil into the mixing bowl .
2) Stir everything thoroughly .
NOTe
► The dough should have a slightly crumbly
consistency and not be too sticky .
If the dough is too sticky, add a little durum
wheat semolina . If the dough is too dry/crum­
bly, add a little water .
3) Leave the dough to stand for about 1 hour .
The dough is now ready for further processing .

Making pasta sheets

WARNING! RISK of INjURy!
► Never reach into the rollers 2 of the pasta
attachment .
► Make sure that your clothing, hair or jewellery
do not get caught in the rollers 2 .
ATTeNTiON! PrOPerTy dAmAge!
► Do not operate the appliance for longer than
10 minutes in one session with the pasta
attachment fitted . Otherwise, the appliance
may overheat!
► Do not process frozen dough!
1) Start by turning the settings knob 4 to the
largest pasta thickness:
–
Pull the settings knob 4 out a little and,
at the same time, turn it until the position
marking 3 points to the dough thickness
"8" .
–
Let go of the settings knob 4 and turn it a
little, if necessary, so that it clicks into place
in the required position marking 3 .
SKV 1200 A1 - B
2) Form the dough so that it is about 1/3 of the
feed width of the rollers 2 and about 0 .5 cm
thick .
3) Insert the food processor plug into a mains
power socket .
4) Set the rotary switch of the food processor to
level 1 .
5) Sprinkle a little flour onto the dough .
6) Feed the dough into the rollers 2 . It will be
drawn in automatically and fed out on the
underside of the pasta attachment .
7) Reduce the set dough thickness by one level by
adjusting the setting knob 4 down a level .
8) Feed the dough back through the rollers 2 .
9) Repeat steps 7) and 8) until the dough has
reached the required thickness .
10) Remove the power plug from the mains power
socket .
You can now cut the rolled dough into the required
shapes .

Dismantling

WARNING! RISK of INjURy!
► Always disconnect the appliance from the
power supply before dismantling the grater
attachment!
1) Press the small button next to the locking
connection 1 on the food processor and turn
the pasta attachment and pull it off the food
processor .
13 ■
│
GB│MT