Table of Contents
Advertisement
1
32"/43" Series:
1. Unplug the connector from the SSB.
Caution: be careful, as these are very fragile connectors!
2. Remove fixation screws [1] and connector [2] from the IR board control unit.
3. Press the snap that marked by blue box below backward then take out the IR board.
When defective, replace the whole unit.
1
3.2.4 Small Signal Board (SSB)
Caution: it is mandatory to remount all different screws at their original position during re-assembly. Failure to do so may result in damaging the SSB.
1.
Unplug all connectors [2] from the SSB.
2.
Remove all the fixation screws [3] from the SSB.
2
2
3
Advertisement
Table of Contents
