Canon Pro9000 Mark II Service Manual page 18

6 times Internal
temperature
error
7 times Ink absorber
full
8 times Print head
temperature
rise error
9 times EEPROM
error
10 times VH monitor
error
11 times Carriage lift
mechanism
error
12 times AP position
error
13 times PRSB
position
error
17 times Paper eject
encoder
error
paper feeding from the
rear tray.
[5400] The internal temperature is
not normal.
[5B00, The ink absorber is
5B01] supposed to be full.
Error codes:
5B00: Overseas
5B01: Japan (In
EEPROM information
print, "5B00" is printed
instead of "5B01.")
[5200] The print head temperature
exceeded the specified
value.
[6800, A problem occurred in
6801] reading from or writing to
the EEPROM.
[B200] The VH (print head drive
voltage) is out of the
specified value.
[5110] The carriage did not move
up or down properly.
[6A00] An error occurred in the
AP motor (on the right
side of the ASF unit).
[6B00] An error occurred in the
PRSB motor (on the left
side of the ASF unit).
[6010] An error occurred in the
paper eject encoder signal.
- ASF unit
- Logic board
(1) Cable connection
(2) Part replacement:
- Carriage unit
- Logic board
- Print head
(1) Ink absorber condition
(2) Part replacement:
- Ink absorber kit
(3) Ink absorber counter value in the
EEPROM;
reset the ink absorber counter.
(1) Print head condition
(2) Cable connection
(3) Part replacement:
- Print head
- Logic board
(1) Part replacement:
- Logic board
(1) Part replacement:
- Print head and logic board
- Carriage unit
- Power supply unit
(1) Foreign material or paper debris that
obstructs the carriage movement;
remove foreign material.
(2) Part replacement:
- Carriage lift gear unit
- Carriage lift sensor
- ASF unit
- Logic board
(1) Foreign material or paper debris around
the ASF unit;
remove foreign material.
(2) Cable connection
(3) Part replacement:
- ASF unit
- Logic board
(1) Smearing or scratches on the EJ slit disk
film;
clean the EJ slit disk film.
(2) Foreign material or paper debris in the
15 / 56
(Replace them at the same time.)