Mirror Lockup; Take The Picture - Canon EOS-1Ds Instruction Manual

Mirror Lockup

Mirror lockup is enabled with C.Fn-12. (→p.136) This prevents mirror-caused vibrations which
may blur the image during close-ups or when a super telephoto lens is used. To set this
Custom Function, see "Setting a Custom Function" on page 132. When mirror lockup is set,
the camera operates as follows.
•
When using mirror lockup, Remote Switch RS-80N3 (optional) is recommended. (→p.167)
•
In very bright light such as at the beach or ski ground on a sunny day, take the
picture promptly after mirror lockup.
•
During mirror lockup, do not point the camera lens at the sun. The sun's heat can
scorch and damage the shutter curtains.
•
If you use mirror lockup with the self-timer for a bulb exposure, there will be a
shutter release sound when you release the shutter button during self-timer
operation. This is not the sound of the shutter release.
•
During mirror lockup, the drive mode will be set to single-frame shooting (
override the current drive mode (single or continuous).
•
If mirror lockup is used with the self-timer, pressing the shutter button fully the first
time will lock up the mirror and release the shutter 10 seconds or 2 seconds later
(depending on the delay time selected).
104
Press the shutter button fully and
1
release it.
s
The mirror locks up, and after 30 seconds, it will go
back down automatically. Pressing the shutter
button fully again locks up the mirror again.
Press the shutter button fully again to
2

take the picture.

s
The picture is taken and then the mirror goes back
down.
) to