Philips 4000 Service Manual page 20

PHILIPS 4000 and 3000
The machine is programming the
amount of espresso to be brewed.
The machine is programming the
amount of long espresso to be
brewed.
The machine is programming the
amount of classic coffee to be
brewed.
Warning Signals (Yellow Colour)
The machine is warming up.
The machine is performing the
rinse cycle. Wait until the machine
has completed the cycle.
The machine needs the
"INTENZA+" water filter to be
replaced.
You need to descale the machine. Press the "
process. Follow the steps described in the "Descaling" chapter of this manual.
If you want to descale the machine later, press the " " button to continue
using the machine.
Please note that not descaling your machine will ultimately make it stop
working properly. In this case, repair is NOT covered under your warranty.
Warning Signals (Red Colour)
Completely insert the drip
tray with the coffee grounds
drawer into the machine
and close the service door.
Fill the coffee bean hopper.
The brew group must be
inserted into the machine.
Empty the coffee grounds
drawer. Wait 5 seconds before
reinserting it.
The machine is out of order. The error code is displayed in the right bottom
corner. For error codes 1 -3 - 4 - 5, please refer to the "Troubleshooting" chapter.
For any other error codes, follow the instructions below:
Exx
Turn off the machine. Turn it back on after 30 seconds. Try this 2 or 3 times.
03 BRIEF INSTRUCTIONS
Espresso brewing using pre-
ground coffee in progress.
Long espresso brewing using
pre-ground coffee in progress.
Classic coffee brewing using pre-
ground coffee in progress.
The brew group is being
reset due to machine reset.
Fill the coffee bean hopper with
coffee beans and restart the
cycle.
Prime the circuit.
" button to start the descaling
Fill the water tank.
Set the "ESPRESSO" or "COFFEE"
selection lever to "COFFEE" within
30 seconds to complete brewing.
Set the "ESPRESSO" or "COFFEE"
selection lever to "ESPRESSO"
within 30 seconds to complete
brewing.
4/13