Advertisement
Headlights
Refer to Replacement Parts section when replacement of
headlight bulbs is necessary.
Replace headlight bulbs as follows:
1.
Fully raise the hood of the tractor.
2.
Unplug the wire harness leads from the headlight socket
terminals. Note which wire connects to each terminal
before disconnecting.
3.
Rotate the socket assembly approximately 1⁄4 turn to align
the socket tab with the reflector housing notch; then
withdraw the bulb and socket assembly from the reflector
housing. See Fig. 7-2.
Socket Tab
Reflector Notch
Figure 7-2
4.
Push the bulb inward and turn counterclockwise to remove
from the socket.
5.
Align a locking post of the bulb base with the notch in the
socket, then push the bulb inward and turn clockwise to
lock. See Fig. 7-2.
6.
Align the socket tab with the notch of the reflector
housing; then push the socket inward and turn as
necessary to lock the socket in the housing:
7.
Connect the wire harness leads to the appropriate socket
terminals.
Fuses
Always use the same capacity fuse for replacement. If the
electrical system does not function, check the fuses.
To replace a fuse, pull the old fuse from the fuse holder and
install the new fuse.
Terminal
Socket
Reflector Housing
Cutting Deck Removal
WARNING!
Before removing the mower deck,
place the PTO switch in the "OFF" position, engage
the parking brake, turn the ignition key to the "OFF"
position and remove the key from the switch.
Disconnect the spark plug wire for additional safety.
1.
Position the tractor and mower deck on a firm, level
surface.
NOTE: Carefully positioning a piece of 2x4 under the
center, rear of the cutting deck to raise it up slightly will aid
in completing the following steps.
WARNING!
When handling the mower deck, be
careful not to cut yourself on the sharp blades. The
deck idler arm lever is spring loaded. Release it
slowly.
2.
Place the cutting height lever in the L position and use the
lift switch to lower the lift links.
3.
Working on the left side of the tractor, insert a 1⁄2" drive
ratchet wrench, set to loosen, into the square hole found
on the idler bracket.
4.
Pivot the wrench rearward to move the deck drive pulley
forward. See Fig. 7-3.
Figure 7-3
WARNING!
Avoid pinching injuries. Never place
your fingers on the idler spring or between the belt
and the pulley while installing the belt.
5.
Carefully remove PTO belt from around the deck drive pulley.
6.
Feed the belt forward and remove from around the mule
drive pulleys (See Fig. 7-8 on page 29) and the tractor's PTO
clutch pulley.
7.
Looking at the cutting deck from the left side of the tractor,
locate the deck support pin on the rear left side of the deck.
S
7 — S
27
ection
ervice
Advertisement
