Table of Contents
Advertisement
Other issue
The IR sensor is not functioning.
In power-saving mode, when the input source is
DisplayPort, PC display settings cannot be saved.
When booting the PC with the input source set to
DisplayPort, the BIOS and booting screens do not appear.
Make sure the sensor light turns on when a button is pressed on the remote control.
•
If the light does not turn on, turn the power switch off and then on again.
If the sensor light still does not turn on after the power switch is turned off and then on
again, an internal jack may be disconnected.
Contact your nearest service center to have the product serviced.
Go to
System
→
Power Control
and set
PC display output settings again. Ensure the set is turned on.
Boot the PC when the set is turned on or when the input source is not DisplayPort.
Max. Power Saving
to Off. Alternatively, configure the
89
Advertisement
Table of Contents
