Overview Of Installation And Removal - NEC E120e-M User Manual

Chapter 2 Preparations
1.3

Overview of Installation and Removal

Install/remove components by using the following procedure.
Installing/removing internal components except for hard disk drives and power supply unit should be done after
dismounting the server module from the module enclosure.
1. If the server is mounted on a rack, use the UID switch to identify the target server.
Refer to Chapter 2 (1.4 Identifying Servers (UID Switch)).
2. If the server module is ON, turn it off.
Refer to Chapter 3 (1. Turning on the Server).
3. Remove the server module from the server enclosure, and put it on a flat rigid desk
Refer to Chapter 2 (1.5 Removing Server Module) for details.
– If you remove the server module from module enclosure, wait at least 30 seconds before insert it
again into enclosure.
– If you are going to install hard disk drive only, you need not to remove the server module. Go to
Step 6.
4. Depending on the components to be installed or removed, follow the procedure in order.
Refer to Chapter 2 (1.5 Removing Server Module) to (1.11 Battery for RAID Controller).
5. Install the server module in module enclosure. Refer to Chapter 2 (2.1 Installation).
6. Install hard disk drives.
Refer to Chapter 2 (1.12 Hard Disk Drive).
7. Install power supply units
Refer to Chapter 2 (1.13 Power Supply Unit).
This is the end of the installation or removal procedures for internal optional devices.
Continue the setup with reference to Chapter 2 (2.2 Connection).
46
CAUTION
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, refer to Safety precautions in Precautions for Use.
• Do not drop the server
• Do not leave the server pulled out.
• Do not install the device with cover removed.
• Beware of high temperatures
• Do not get your fingers caught when installing components
Express5800/E120e-M User's Guide
1. Installing Internal Optional Devices