DeWalt XR LI-ION DCMW564P2 Original Instructions Manual page 42

EnGLIsH
Grass Mulching Insert (Fig. A, F)

DANGER: Remove safety key and battery packs
before removing collection bag, and when installing
mulching insert.
1. Ensure the grass collection bag
before proceeding to step 2.
2. Lift the rear door cover 13
insert 18 fully into the mower as shown in Fig. F.
3. Ensure the rear door cover is down before turning mower on.
Rear Discharge

DANGER: Remove safety key and battery packs before
removing collection bag, and mulching insert.
1. To operate mower in rear discharge mode remove both the
bag and the mulching insert.
2. Be sure rear door cover is down for rear discharge.
nOTE: The rear door is shaped in such a way that the opening
(at the bottom) cannot be completely closed off.
OPERATION

DANGER: To reduce the risk of serious personal
injury, turn unit off, remove safety key, and remove
battery packs before making any adjustments or
removing/installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Packs
(Fig. G)

DANGER: MAKE CERTAIN THE SAFETY KEY IS
REMOVED TO PREVENT ACTUATION BEFORE
REMOVING OR INSTALLING BATTERY.
This mower is designed to operate on two battery packs of
equal capacity. The mower will not operate on a single battery
pack, and If using different capacity battery packs, the smaller
capacity battery pack, when depleted, will cause the unit to
turn off
nOTE: For best results, make sure each battery pack is
fully charged.
To Install Battery Packs
1. Lift and hold the battery port cover
battery ports 23 .
2. Slide a battery pack 19 into each of the two battery ports
until an audible click is heard (Fig. G). Make sure the battery
packs are fully seated and fully latched into position.
3. Close the battery port cover. Ensure the cover is fully closed
before starting mower.
To Remove Battery Packs
1. Open the battery port cover
2. Depress the battery release button
and pull battery pack 19 out of tool.
40
14 is not attached
and slide the mulching
up to expose the
11
11 as described above.
20 on the battery pack
READ THIS INSTRUCTION MANUAL BEFORE
OPERATING YOUR MOWER
Refer to Figure A at the beginning of this manual for a complete list
of components. Save this manual for future reference.

DANGER: Sharp moving blade. Do not operate the
mower in mulching mode if the rear door is not closed
under spring tension as serious injury could result. Take
your mower to the nearest service centre for repair.

DANGER: Do not operate mower unless handle is
locked into position.

DANGER: Sharp moving blade. Never operate the
mower in bagging mode unless the hanger hooks on the
grass catcher are seated properly on the mower and the
rear discharge door rests firmly against the top of the grass
catcher as serious injury could result.

WARNING: Let the mower work at its own pace. Do
not overload.
Adjusting Mower Height (Fig. H)
The height of cut is adjusted by the central cut height
adjust lever.
nOTE: If you are not sure which height to cut, begin mowing
with the cut height adjustment lever
the rear of the appliance and adjust the height down as needed,
as shown in Fig. H.
To Set the Height of Cut
1. Pull the cut height adjustment lever
notch 24 .
2. Move the lever towards the rear of the appliance to raise the
height of cut.
3. Move the lever towards the front of the appliance to lower
the height of cut.
4. Push the height adjustment lever into one of the
locking notches.
Safety Key (Fig. I)

DANGER: Sharp moving blade. In order to prevent
accidental start-up or unauthorised use of your
Cordless Mower, a removable safety key ( 3 ) has been
incorporated into the design of your mower. The mower
will be completely disabled when the safety key has been
removed from the mower.
nOTE: The safety key has a rope attached to allow for
storage on a nail, out of the reach of children. Do not
tether safety key to mower.

DANGER: Rotating blades can cause serious injury.
To prevent serious injury, remove safety key and
battery packs when unattended, or when charging,
cleaning, servicing, transporting, lifting, or
storing mower.
12 positioned towards
12 out of the locking