Related Manuals for Yamaha CDR200tx
Summary of Contents for Yamaha CDR200tx
- Page 1 CDR200tx User Guide Guide de I’utilisateur Bedienungsanleitung P O W R E A W R IT O N / D IS C - 2 0 0 C D R da bl R ec or V O L...
- Page 2 If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Systems Technology, Inc. 100 Century Center Court, San Jose, CA95112, U.S.A.
- Page 3 Laser Diode Properties Material : GaAlAs Wavelength : 780-790 nm Emission Duration : Continuous Laser Output Power : Less than 44.6 W* his output is value measured at a distance 200mm from the objective lens surface on the optical pick-up block. ANSI Class : Class 1 CLASS 1 LASER PRODUCT LASER KLASSE 1 PRODUKT...
- Page 4 • CDR200tx is a sophisticated electronic device. Handle it with care. • If the fuse blows, CDR200tx should be checked by a qualified engineer. Do not just replace the fuse. Replacing the fuse by yourself may cause the protection circuit to be damaged.
- Page 5 Do not block the CDR200tx ventilation slots. Install CDR200tx with at least 10 cm of free space all-around. • Make sure the CDR200tx power cord is not located in a position where it is likely to be walked on or pinched by other equipment.
- Page 6 Important Precautions Operating Precautions • Do not subject CDR200tx to impact or shock when in use. This may impair recording or playback. • Do not place heavy objects on CDR200tx. • Avoid moving CDR200tx from cold to warm places, and avoid sudden room temperature rises, as condensation that could cause CDR200tx to malfunction may occur.
- Page 7 If a disc tray accumulates dust, DO NOT USE IT FOR DISC RECORDING. Always use a clean, dust-free tray for disc recording. If CDR200tx is vibrated while recording, the recording may fail. To avoid such failures observe the following practices: •...
-
Page 8: Table Of Contents
About Discs ... 5 Chapter 2 - Touring Around CDR200tx... 6 Front Panel... 6 Rear Panel... 7 Chapter 3 - Installing the Yamaha CDR200tx Drive... 8 CDR200tx drive settings ... 8 Cable Connection ... 9 Chapter 4 - Operation ... 10 Loading a Disc... -
Page 9: Introduction
Introduction Thank you for purchasing a Yamaha CDR200tx drive. Please read this manual before using the drive in order to make the best use of the superior CDR200tx functions. After reading, please retain this man- ual for future reference. Accessories The package should contain the following items along with the drive. -
Page 10: Cdr200Tx Features
Introduction CDR200tx Features 2xS Recording - 6xS Reading The CDR200tx is a CD-ROM recorder capable of recording at double speed (2xS), or normal speed (1xS). It can read discs at up to 6xS. Compatible with Seven Different Formats The CDR200tx can both record and read seven different formats: CD-ROM, CD-ROM XA, CD-I, CD-DA, CD-Bridge (multisession), CD-Extra, and Video CD. -
Page 11: Orange Book Compatible Recording
Introduction Orange Book Compatible Recording Track at Once In this mode, data can be recorded to disc one track at a time. Discs recorded in this mode cannot be played in CD players or CD-ROM drives other than the CD-R drive until the session is closed. Multisession In this mode, data can be recorded to disc in stages (one session at a time). -
Page 12: Chapter 1 - System Configuration
CD-ROM. SCSI card and software Yamaha CDR200tx is a “SCSI” device. You will need to install a SCSI card and some mastering (writing) software in your host com- puter to connect the CDR200tx. -
Page 13: About Discs
About Discs CD-R Discs On the CDR200tx, you can use conventional CD-R discs that con- form to the Recordable Compact Disc Systems Part II (Orange Book). Yamaha recommends the following Yamaha CD-R discs: > CDM12Y63 > CDM12Y74 > CDM12Y74M ( 120mm, 74 minutes) >... -
Page 14: Chapter 2 - Touring Around Cdr200Tx
This control adjusts the volume level of the headphone output. Rotating the control clockwise will increase the volume level. 4 ON/DISC LED This indicator lights up in orange when the CDR200tx is powered on, and lights up in green when the CDR200tx contains a disc. 5 READ/WRITE LED This indicator lights up in green when data is being read, and flashes... -
Page 15: Rear Panel
1 AC IN Connect the included power cable here. 2 CDR ID Use this switch to set a unique SCSI ID number for the CDR200tx. 3 TERMINATOR This switch is used to set termination. Refer to the terminator setting section for details. -
Page 16: Chapter 3 - Installing The Yamaha Cdr200Tx Drive
TERMINATOR Terminator OFF TERMINATOR — Use this setting if the CDR200tx is the last device in the SCSI daisy-chain. — Use this setting if devices other than the CDR200tx are in the SCSI daisy-chain and the CDR200tx is not the last device. -
Page 17: Cable Connection
(1) or (2), and connect the other end of the SCSI cable to the host computer. The CDR200tx is not supplied with a SCSI cable. You will need to obtain one that will fit the drive and the host computer connectors. -
Page 18: Chapter 4 - Operation
Chapter 4 - Operation Chapter 4 - Operation Loading a Disc 1. Press the eject button to open the tray. 2. Carefully place the disc, label-side up, on the disc tray. 3. Press the disc tray softly or press the eject button again to close the disc tray. -
Page 19: Ejecting The Disc
Press the eject button to eject the disc. Note: You cannot eject the disc if the SCSI command prohibits the eject operation while the CDR200tx is reading data. Caution: Be sure to remove the disc after it is completely ejected. (Trying to remove the disc before it is completely ejected may cause the drive to malfunction.) -
Page 20: Troubleshooting
Troubleshooting Troubleshooting If CDR200tx is not performing as expected, look up the symptoms in the following table, then see what to do. Symptoms The power to the CDR200tx is off The power to the computer is off The CDR200tx is not recognized by the computer. -
Page 21: Appendix
Specifications Interface Data Capacity Record/Read Speed Data Transfer Rate Burst Transfer Rate Buffer Size Access Speed Installation Disc Loading Audio Out (normal speed) Power Consumption Power Supply Environment Dimensions (WxHxD) Weight Specifications are subject to change without prior notice. SCSI 2 1.2m/sec: 666MB 1.4m/sec: 540MB 1xS (real-time), 2xS, 4xS(read), 6xS (read) -
Page 22: Front Panel Indicator Key
Appendix Front Panel Indicator Key on: green flashing: green on: orange flashing: orange Status Reset Ready (no disc) Inserting disc Ejecting disc Ready (disc inserted) Seeking Preparing to write Writing Writing (test mode) Playback Error occurred — off ON/DISC Read/Write —... - Page 23 YAMAHA CORPORATION Electronic Systems Division VY75130-0...