Quick Start - Huawei ETS2506 User Manual

Do as follows, you can manage how to answer and make a call through the FWT
in a short time.
1. As shown in Figure 3-4, insert one end of the spiral cord into the jack at the
end of the handset and the other end into the jack on the main unit.
2. Install the power adapter or the battery. For the details, refer to the "4
Installation Description".
3. Turn on the FWT and wait a few seconds for the FWT searching and
registering in the network until indicators such as time and signal appear.
Adjust the antenna to ensure fine signal strength.
4. Pick up the handset and input a call number after hearing the dialing tone.
Pressing <CALL/REDIAL>, you can dial out the number.
5. When there is a call incoming and the FWT is in standby state, you can pick
up the handset or press <HANDFREE> or <CALL/REDIAL> to answer the
call.
6. You can set the time for auto dialing. By default, it is seven seconds. Perform
the following steps for this function:
Press <MENU> to access the function menu.
Press the <UP>/<DOWN>scroll key to select [Settings].
Press the <UP>/<DOWN> scroll key to select [ Personal ] .
Press the <UP>/<DOWN> scroll key to select [Auto-dial Time].
Note:
[Auto-dial Time] means that the phone number you keyed in is dialed
automatically at the time you set without pressing the <CALL> key. If
the time you set for auto dialing is too short, an incomplete number may
be dialed before you key in the whole number.
5

Quick Start

31
HUAWEI