Table of Contents
Advertisement
IPv6 Connection Type: Auto-Configuration (Stateless/DHCPv6)
In the following section we'll discuss the parameters that can be configured when setting up an Auto-Configuration (State-
less/DHCPv6) connection. This is a method of connection where the ISP assigns your IPv6 address when your router re-
quests one from the ISP's server. Some ISP's require you to make some settings on your side before your router can connect
to the IPv6 Internet.
The following parameters can be configured:
My IPv6 Connection is:
The following parameters can be configured:
Obtain IPv6:
Use the following IPv6:
Primary DNS Server:
Secondary DNS Server:
Use the section to configure the internal network settings of your router. The LAN IPv6 Link-Local Address is the IPv6 Ad-
dress that you use to access the Web-based management interface. If you change the LAN IPv6 Address here, you may need
to adjust your PC's network settings to access the network again. DHCP-PD can be used to acquire a IPv6 prefix for the LAN
interface.
The following parameters can be configured:
Enable DHCP PD:
LAN IPv6 Address:
LAN IPv6 Link-Local Ad-
dress:
S
W
R
AMSUNG
IRELESS
OUTER
Select the appropriate IPv6 Connection Type used for this configuration here.
Select this option to obtain the DNS Server addresses automatically.
Select this option to manually enter the DNS Server addresses used.
Enter the primary DNS Server address used here.
Enter the secondary DNS Server address used here.
Select this option to enable DHCP PD.
Enter the LAN IPv6 address used here. This address must be in the '/64' subnet.
Displays the LAN IPv6 Link-Local address used here.
U
M
SER
ANUAL
P
61
AGE
Advertisement
Table of Contents
