Table of Contents
Advertisement
4
Operating procedures
4.4
Attaching the ready indicator /
exchanging a hook-and-loop fastener
The ready indicator can be attached using a hook-and-loop fastener (fastener hooks and
fastener loops) in a place where it can be easily checked during examination. Attachment
of fastener loops on the ready indicator and fastener hooks where you want to attach the
ready indicator allows users to easily remove and replace the ready indicator.
Information
The fastener hooks and fastener loops can be applied to either the ready indicator or
to the location where you want to attach the ready indicator. Note that the fastener
hooks and fastener loops must be used in pairs.
4.4.1
At installation, a pair of hook-and-loop fasteners are attached. If the fastener loops or
fastener hooks are torn off or they become less adhesive, or when the attachment
position needs to be changed, exchange the fastener loops or fastener hooks for new
ones.
4.4.2
This is suitable for cases in which the ready indicator and the image-capture computer
can be moved, including such environments as mobile X-ray environment.
1
Attach hook-and-loop fasteners.
i)
The fastener loops are attached using the adhesive
on the back.
Remove any oil, water, or dust on the attachment side of the hook-and-loop
fastener using a cloth slightly damped with a neutral detergent.
36
Removing the hook-and-loop fastener from
the ready indicator and attachment position
Attaching the ready indicator behind the
monitor of a control software-installed laptop
computer
Apply fastener loops to the ready indicator (on
the side of the volume buttons) on the
positioning rib ( ).
Information
Positioning rib
Fastener loop
Advertisement
Table of Contents
