NEC Express5800 Series Maintenance Manual page 128

Chapter 3 Appendix
megasas2
129
While the system is running
Microsoft-Windows-Time-
Service
134
When installing an OS, starting system,
or applying Starter Pack
disk
153
When creating logical drive by Universal
RAID Utility
Service Control Manager
7023
When installing an OS
Service Control Manager
7023
When installing an OS
Microsoft-Windows-
DistributedCOM
10010
When installing an OS
Microsoft-Windows-
WinRM
10149
When installing an OS
Application Event Log
Microsoft-Windows-
Security-SPP
1015
When installing an OS
128
Reset command is issued to device \Device\RaidPort(x).
Warning
(omitted hereafter)
This event does not affect system operation If this message is logged
because OS has succeeded retry process.
NtpClient was unable to set a manual peer to use as a time source
because of DNS resolution error on 'time.windows.com,0x9'. NtpClient
Warning
will try again in 15 minutes and double the reattempt interval thereafter.
Error: (0x80072AF9)
If this event is not logged after connecting with Internet, this event does
not affect system operation.
I/O operations were repeated on logical block address of disk.
Warning
* Message may differ from this depending on system environment.
This event does not affect system operation if logged when logical
drives were created by Universal RAID Utility.
The Network List Service terminated with the following error:
Error
Device is not ready.
If this event is logged only upon OS installation and is not logged
repeatedly, it does not affect system operation.
The IP Helper service terminated with the following error:
Error The specified service is invalid, or valid device is not associated with the
service.
If this event is logged only upon OS installation and is not logged
repeatedly, it does not affect system operation.
The server {XXXXXXXX-XXXX-XXXX-XXXX-XXXXXXXXXXXX} did not
Error
register with DCOM within the required timeout.
Go to the following URL for detailed information.
http://support.microsoft.com/kb/956479/
Warning The WinRM service is not listening for WS-Management requests.
If this event is logged together with ID 7036 "Service Control Manager
(Windows Remote Management (WS-Management) service is changed
to halt state.), it does not affect system operation.
If these events are not in pair and WinRM Event 10148 (The WinRM
service is not listening for WS-Management requests.) is output
immediately after this event, it is not problem in system operation.
Description: Detailed information of HRESULT
Warning
Returned hr=0xC004F022, original hr=0x80049E00
Unless the event is registered after license authentication, this event
does not affect system operation.
Express5800/E120e-M Maintenance Guide
2. List of Windows Event Logs