NEC Express5800 Series Maintenance Manual page 120

Chapter 3 Appendix
Error Message
C203 CPU Configuration
change is detected.
C300 Out-of-band setup
configuration failure
C301 SDR mismatch error.
C302 Hardware configuration
error.
C310 Hardware configuration
of cooling is
insufficient.
C320 Unmatched PSUs.
C321 System power
consumption is
out-of-range in PSUs.
C322 No information for
system power
consumption check.
ME is in Recovery Mode. Intel(R) Node Manager is in
C501
120
Cause
The CPU configuration has changed
since the previous startup.
Configuration change requested by
remote terminal via network failed.
Inconsistency in the hardware
information of the sensor data record
was detected
Illegal hardware configuration was
detected.
Detected that cooling power is
insufficient in this hardware
configuration.
Unmatched power supply units are
configured.
System power consumption exceeds
the power output capacity limit.
No information is acquired in
checking system power
consumption.
Recovery Mode.
Express5800/E120e-M Maintenance Guide
1. POST Error Message
Solution
When Check previous system Config is
enabled in Server of the setup, this message
appears if the configuration was changed
since the previous startup. If this message
appears even when no configuration change
has been made, contact your service
representative.
Unplug the power cord, wait for at least 30
seconds, then restart the server. If the same
error is detected repeatedly, contact your
sales representative.
Contact your sales representative.
Check the installation status of power supply
units. Unplug the power cord, wait for at least
30 seconds, then restart the server. If the
same error is detected repeatedly, contact
your sales representative.
Check the jumper switch setting on
motherboard. Unplug the power cord, wait
for at least 30 seconds, then restart the
server. If the same error is detected
repeatedly, contact your sales
representative.