Table of Contents
Advertisement
The tab RX/TX allows similar functionality as the tab Console, but enables to send data
character by character manually or based on a cyclic sending interval which can be determined
by the user.
The tab File enables to send data files instead of character strings. After the definition of a
connection interval, the file directory of the device can be browsed to select the desired file.
7.2 Two Pro Kits with PAN1740/1740A Adapter Board
Similar to the previous example it is possible to use two of Dialog's Pro Kits with
PAN1740/1740A Adapter Boards to emulate a serial port.
Set up one Pro Kit with the application software sps_device and the other Pro Kit with the
application software sps_host by downloading the .hex-files onto the Pro Kits.
The host will be discovered and connected to the device.
A Terminal can be launched (for instance the Smart Snippet Terminal) and ex-
change data.
7.3 Two PAN1740/1740A USB Sticks
Establish a serial port connection with two PAN1740/1740A USB sticks
The da14580_config.h of the host and the device source code has to be amended.
1. Change the flow control mode from the default hardware flow control to software flow
control.
Design Guide Rev. 1.0
Note the hardware flow control changes (jumper or source code) required as
7.1 Pro Kit with PAN1740/1740A Adapter Board
explained in
PAN1740/1740A Bluetooth Module
7 Dialog Serial Port Service (DSPS)
(iPod).
Page 28
Advertisement
Table of Contents
