Panasonic PAN1740 Design Manual page 20


6.1.2 Board Setup
The tab Board Setup in the toolbox has to be used before any other tool as it establishes a
communication with the development kit during the boot sequence and comes along with two
lists.
The upper list contains UART ports with its baud rate, which connect the FTDI chip version
"DA14580". The other list selects the GPIO pin which enables 6.8 V for OTP programming.
6.1.3 UART Booter
The UART Booter enables to download application code directly into the RAM of the
"DA14580" to test its behavior in terms of power consumption for instance.
1. Click Browse (1) to select the desired code (.bin, hex., .ihex).
2. Click Download (2) and observe the Log (3) to handle the requested hardware reset.
3. Optional: Click Start Terminal (4) to receive debugging information via UART.
Design Guide Rev. 1.0
Note that an activated UART connection disables the OTP connection with the
result that the UART connection has to be closed to enable the OTP
connection and vice versa.
PAN1740/1740A Bluetooth Module
6 Smart Snippets
Page 20