Installing Optional Vga Module - Dell OptiPlex XE4 Tower Service Manual

2. Disconnect the VGA module cable from the connector on the system board.
3. Remove the VGA module from the computer.

Installing optional VGA module

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the optional VGA module and provide a visual representation of the installation
procedure.
Steps
1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket, push the bracket to release
the bracket, and then lift the bracket out from the system.
Removing and installing components 81