ABB ACH550 Quick Start Manual page 5

Hide thumbs Also See for ACH550:

Step 9: Connect your 24VDC power to the 2 terminals on the 64652745 (OPEX-01 Interface Board)

Option A: Gathering the programming data - Panel installation and considerations

Step 1: Connect Ethernet cord to RJ45 connector in control panel (ACH-CP-B) and on 64652745 (OPEX-01 Interface

Board)

*Note: All of the control wiring has been removed, you will encounter alarms and faults when power is applied to the

board. What you can expect are motor related faults such as Fault 9 (Motor Over Temp), Fault 18 (Thermal Failure),

Alarm 2010 (Motor Over Temp), Alarm 2021 (Missing start enable). The drive is expecting to see a motor based on the

programming. If you reset or bypass these faults and navigate through parameters, you will be able to gather the data

needed. If you make changes to the existing configuration to avoid these faults and alarms, the data you retrieve may

not be accurate.

LVD-EOTKN094U-EN REV A

Effective: 2022-06-30