Direct Recording To Hdd; Setting The Record End Time During Direct Recording (Simple Recording Timer) - Sharp DV-HR300U Operation Manual

Direct Recording to HDD

HDD
Explained below is the standard procedure
for recording the program being viewed onto
HDD.
• A maximum of 12 hours can be recorded
onto HDD in one direct recording session.
• A maximum of 199 programs can be
recorded (saved) onto HDD.
NOTE
• The content being recorded will not be
recorded if power failure occurs or if power
cord is accidentally unplugged.
* Also direct recording to a DVD-R/RW is
possible (page 40).
Preparation for Direct Recording
• When you record SAP broadcast, set "SAP
SETTING" to "ON" (see page 98).
1
Press HDD to select HDD mode .
• The HDD button on the front of the
Recorder lights up.
• HDD mode is selected automatically
when the power is turned on.
2
Press the Number buttons or
CH' / " to select the channel to
be recorded.
3
Press REC MODE to select the
recording mode.
• The recording mode changes as
shown below each time the button is
pressed.
FINE SP LP EP
• Recording mode set by selecting
"MNgg" is the recording mode set
on the "MANUAL REC. MODE"
screen (page 42).
4
Press Æ Æ Æ Æ Æ REC during broadcast
viewing.
• Recording begins and REC icon
displays in TV screen.
• REC indicator (for HDD) on the front of
Recorder is lit red during recording.
REC icon
HD D
REC
OR IG IN AL
REMAIN 19h8m
F I NE
1 / 1
1 / 1
0 0 : 1 9 : 3 0
5
Press REC PAUSE to pause
recording.
• Record Pause does not work during
Chasing Playback.
• During pause, the REC indicator (for
HDD) on the front of the Recorder
blinks.
REC PAUSE icon
Recording to HDD
6
Press REC PAUSE to resume
recording.
7
Press REC STOP to stop record-
ing.
• "DATA IS BEING RECORDED TO
DISC" displays on TV screen and
recording stops.
NOTE
• You cannot record programs whose
recording is prohibited.
• Timer recording cannot be performed
during direct recording. To perform timer
recording, stop direct recording before the
preset time for timer recording.
Inserting Chapter Marks
Manually during Recording
Press CHAPTER MARK (under the cover).
• "RECORDED CHAPTER MARK. " is
displayed and chapter mark will be
inserted.
• You cannot insert chapter marks during
Simultaneous Recording/Playback.
Setting the Record End
Time during Direct
Recording (Simple
Recording Timer)
HDD
MNgg
1
Press Æ Æ Æ Æ Æ REC on the remote
control during recording.
• The "SET STOP Timer" screen is
displayed.
2
Press ' / " to set the end time.
• The end time can be set in units of 15
minutes.
• Total recording time cannot exceed
12 hours so the end time has to be
set accordingly.
• Press EXIT to stop setting midway
through.
3
Press SET/ENTER.
• The record end time is set, and the
clock mark lights up on the front
display panel.
SET STOP TIME.
STOP TIME 10 : 30 PM
SELECT ENTER
ENTER
39