Toro 120-8506 Installation Instructions

License Plate Kit
Multi-Pro
Model No. 120-8506
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1
Installing the License Plate
Bracket
Parts needed for this procedure:
1 Plate light
1 License plate bracket
2 Phillips-head screw (10-24 x 5/8inch)
2 Lock nut (10-24)
1 License plate bracket
4 Hex-head flange screw (5/16-18 inch)
1 Lock nut (5/16 inch)
Procedure
1. Install the plate light assembly to the license plate
bracket using two phillips-head screws (10-24 x
5/8inch) and two lock nuts (10–24) as shown in
Figure 1.
© 2011—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® 5800 Turf Sprayer
Description
Plate light
License plate bracket
Phillips-head screw (10-24 x 5/8inch)
Lock nut (10-24)
License plate bracket
Hex-head flange screw (5/16-18 inch)
Lock nut (5/16 inch)
No parts required
Register at www.Toro.com.
Qty.
1
1
2
2 Install the license plate bracket.
1
4
1
–
Connect to the wire harness.
G0171 18
Figure 1
1. Phillips-head screw (10-24
x 5/8inch)
2. License plate bracket
2. Install the light and bracket assembly to the mount
using two hex-head flange screws (5/16-18 inch) and
two lock nuts (5/16 inch) as shown in Figure 2.
Form No. 3369-438 Rev A
Installation Instructions
Use
4
3
2
3. Plate light assembly
4. Lock nut
Original Instructions (EN)
Printed in the USA
All Rights Reserved
1