Rear Panel Layout; Remote Control - Q-See QT528 User Manual

2.4 Rear Panel Layout

Item
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16

2.5 Remote Control

Uses two AAA size batteries, to install batteries:
Step1: Open the battery cover of the Remote Control
Step2: Insert batteries. Position the poles (+ and -) correctly
Step3: Replace the battery cover
Notice: If the remote does not work:
1. Check batteries poles
2. Check the remaining charge in the batteries
3. Check to see if IR controller sensor on DVR is blocked
If it still doesn't work, contact the Q-See customer service dept to replace the remote control.
The interface of remote controller is shown in Fig2.6 Remote Controller.
Name
PTZ Connect to speed dome. Y means "+", Z means "-"
K/B Connect to PTZ keyboard
ALARM IN Connect to external sensors 1-8
NET Network port
VGA port VGA output, connect to monitor
Video out Connect to TV/monitor
Video in Video input channels from 1-8
Audio in 4 Channels Audio input
POWER SWITCH Power on/off
+ 5V and GND +5 V and Grounding
ALARM OUT 1-ch relay output. Connect to external alarm.
To connect external USB devices like USB flash, USB HDD
USB port
for backup or update firmware.
Connect to monitor as an AUX output channel by channel.
Spot out
Only video display, no menu
Audio out Audio output, connect to amplified speaker
POWER INPUT DC12V
FAN For cooling the device
Fig 2.5 Rear Panel
Description
Tab 2.1 Back Panel Ports
9