Table of Contents
Advertisement
3. REAR PANEL AND SYSTEM CONNECTIONS
3.1 Back Panel Connections
The power cable and input, output signal terminals are all on the back of the DVR, including
connections to monitor, cameras, etc. The terminals and sockets on the back panel of the DVR
are shown on the illustration below.
1. Video input CH1-CH16 2. Main Video output 3. Assistant monitor (Second monitor) 4. S-
Video out 5. Audio input 6. Audio output 7. Ethernet port 8.USB port 9.power 10.debug port
11.Alarm and RS485port defined:
(1-12: sensor1-sensor12; 13, 20, 24, 25: GND, 14-17: sensor 13-sensor16, 18: RS485A 19:
RS48521: COM 22: NC 23: NO)
3.2 Video & Audio Connections
The DVR can support up to 16 cameras video input at the same time.
Video In 1
CH1
CH2
CH3
CH9
CH10
CH11
The DVR can connect 4 channel's audio input, but you can only select one for recording. To
display the DVR picture, the DVR video output signal should be transferred to your TV set or
monitor. Any TV set that has a "video input" terminal is suitable for displaying the image. The
figure above shows the video and audio signal line connection.
Notice: you can only connect one audio input at any one time, which means, if you
connect an audio input to CH1, you cannot connect any to CH2 through CH4.
Video In 16
CH4
CH5
CH6
CH7
CH8
CH12
CH13
CH14
CH15
CH16
Main
Assisant
S Video
Out
Out
Out
IN
OUT
1
2
OUT
OUT
S VIDEO
3
4
AUDIO
Microphone
10
Advertisement
Table of Contents
