Table of Contents
Advertisement
Touch Panel
Operating buttons/Screen panel (Touch panel)
All indicators are lightening to facilitate explanation.
Display window (Shows wash time, rinse cycles, spin
time, time for dry using "Timer", etc.)
This indicator shows the current
process of the program
(Wash/Rinse/Spin/Dry)
Remaining time
ECONAVI (P.18)
Change the operation contents of Wash/Rinse/Spin
The setting content is displayed on the display
window when operating the buttons.
You can use each process singly, or can use them
in combination with your preferred settings. (P.26)
After start, pressing "Pause" can change the
settings during the "Wash" cycle.
If you press these buttons during operation, you
can check the remaining time and the number of
rinses for each process.
To change the operation contents (Wash/Wash&Dry/Dry)
Press
to change the operation contents (Wash/Wash&Dry/Dry)
"Wash"
"Wash&Dry"
"Dry"
8
Child Lock has
Water temperature
been set. (P.7)
is high. (P.7)
Change the Dry mode (P.29)
Set the fi nish time (How many hours later)
Setting range: 1 to 24 hours by the hour.
For details of the program, time, etc. (P.47)
Set Child Lock (P.7)
Press 5 seconds or more to set/cancel Child Lock.
(P.7)
The door is locked (P.7)
The operation is switched each
time the button is pressed.
The preset timer is being set. (P.23)
Clean the dry fi lter. (P.31)
Select the Program (P.18)
Available programs are
indicated. The program that
has been selected blinks.
Wash with hot water (P.19, 26)
Set Auto (Auto Tub Clean) (P.11, 22)
Change the operation contents (Wash&Dry) (P.18, 22)
How to use the touch panel
Touch (press) the buttons softly to operate.
Attention
If water, detergent or softener is attached to the touch panel, turn the power off , and wipe it off with a
wrung-out towel, etc. immediately.
(Operation error may occur.)
Do not touch the panel with the sharp point such as a nail, pin, ballpoint pen, etc.
Note
You cannot operate with rubber gloves on.
Press to Start/Pause operation
Also press to open the door during operation.
(P.7)
Power button
If you do not press the Start/Pause button within
10 minutes after the appliance has been
switched on, the appliance automatically turns
off .
The power does not turn on
immediately as long as the indication
at right is displayed after power off .
To turn the appliance on, wait until this
display disappears.
Anti-crease is set or performed. (P.10, 23)
Also press to reset the program.
→ →
9
Hide quick links:
Advertisement
Table of Contents
