Sealey CP20VWL Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or
9
damaged DO NOT use.
DO NOT shine directly into your, another person's or an animal's eyes.
8
DO NOT allow children to use the lamp.
8
DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.
8
DO NOT attempt to open, disassemble, modify or service the unit.
8
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
8
DO NOT expose to temperatures above 40°C (104°F).
8
Replace only with the battery packs designated for this product.
9
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with
9
cool water and seek immediate medical attention.
2. INTRODUCTION
Cordless work light useful in any workspace with integrated AC and DC power. 360° Movement with SMD LED technology for ultra-bright
illumination. 96 SMD LED Lights producing up to 4000 lumens. Robust design with integrated carry handle and side lights to illuminate the
darkest spaces. Simple on/off switch with two levels of brightness depending on power supply. Powered by either 20V Lithium-ion battery (not
included) or 230V 50Hz 1.5m mains cable with British standard plug.
3. SPECIFICATION
Model No:............................................................. CP20VWL
Charging Time: .................. See Battery Details (not included)
Electrical Class: .......................................................... Class1
Electrical Fuse Rating: .....................................................13A
Electrical Plug Type: ................................................ 3-Pin BS
IP Rating: .......................................IP20 at Lamp Body, IK07
LED Qty: ............................................................................ 96
LED Type: ................................................... SMD LED 6500K
Lumen Output: 2700lm using 20V battery pack (not supplied)
..................................................... 4250lm using mains cable.
Power: ....... 25W using battery pack - 45W using mains cable
CONSUMABLES:
Batteries (not included): CP20VBP2 - 2Ah Battery, CP20VBP4 - 4Ah Battery
CP20VBP6 - 6Ah
Battery Charger (not included): CP20VMC
4. OPERATION
WARNING! Ensure that you read, fully understand, and apply the safety instructions before use.
‰
4.1. USING THE LIGHT
4.1.1. Operate the worklight using the three position rocker switch on the top surface of the unit.
4.1.2. The light has three settings, these are: O = off, I = mains power, II = battery power.
4.1.3. Adjust the position of the lamp surfaces to suit the environment.
4.2. MOUNTING THE LIGHT
4.2.1. The light may be wall mounted by suspending it on two fixings (not supplied) that are positioned at 150 mm centres to suit the size
of the keyhole slots in two of the unit's feet.
© Jack Sealey Limited
20V CORDLESS SMD LED 4000LM WORK
LIGHT - BODY ONLY
CP20VWL
MODEL NO:
Original Language Version
CP20VWL Issue: 2 (2) 22/10/21