Table of Contents
Advertisement
8.
Insert the 2 bolts (1/2 x 5 inches) through the
engine mount bracket holes, ensuring that a flat
washer is fitted against each outer face of the
engine mount bracket, and ensuring that the
bolts pass beneath the bottom of the hitch tube.
Hand tighten the 2 nuts (1/2 inch) as shown in
Figure
7.
1. Hitch tube
9.
Adjust the engine mount bracket so that it is tight
to the hitch. Fully tighten the 2 bolts that you
loosened in step 3.
10.
Ensure that the engine mounting plate is level
and fully tighten the 2 bolts (1/2 x 5 inches)
through the engine mount bracket lower holes.
11.
Place the battery onto the battery tray,
positioning the terminals as shown in
12.
Position the battery hold down on the battery
(Figure
8).
13.
Hold the battery mount strap around the
underside of the hitch tube
14.
On the right side, install a battery bolt through
the washer, battery mount strap, engine mount
plate, battery tray, battery bolt spacer, and hold
down. Loosely install a flange nut
Note:
Ensure that the bolts are installed from
the bottom.
Figure 7
2. Mounting bolt (2)
Figure
(Figure
8).
(Figure
15.
On the left side, install a battery bolt through
the washer, battery mount strap, engine mount
plate, battery tray, battery bolt spacer, and hold
down. Loosely install a flange nut
16.
Ensure that everything is concentric and tighten
the nuts.
g013860
8.
8).
1. Battery bolt (2)
2. Washer (2)
3. Bolt tube
6
(Figure
Figure 8
4. Battery mount strap
5. Flange locknut (2)
8).
g013862
Advertisement
Table of Contents
