Table of Contents
Advertisement
Important:
This kit can only be applied to
a ProPass that is equipped as a tow-behind
machine.
Preparing the Machine
CAUTION
Installing the kit before disconnecting all
external hydraulic and electrical sources
may expose you to electric shock and/or
pressurized hydraulic fluid, causing serious
injury or death.
Before installing the power pack, disconnect
all external hydraulic and electrical power
sources.
1.
Park the machine on a level surface, lower the
jack stand, disconnect it from the traction unit,
and chock the front and back of the wheels.
2.
Following the instructions given in the Operator's
Manual for the machine, remove the Twin
Spinner and secure the hydraulic power and
return hoses.
Important:
Some ProPass models have a
pre-drilled chassis rear wall. If your machine
has a pre-drilled chassis rear wall, refer to
Mounting the Engine (page
3.
Remove and retain the 2 mounting bolts from
the chassis rear wall to allow the hydraulic tank
to be mounted.
4.
Ensure that the chassis rear wall is clear to
mount the hydraulic tank.
5.
Remove the hydraulic tank assembly from the
crate.
6.
Support the hydraulic tank from underneath and
position the tank against the chassis rear wall.
The tank should be centered evenly from left to
right and should be positioned vertically
1).
5).
(Figure
4
1. Hydraulic tank
7.
Ensure that the inlet and outlet fittings and the
hose guide mounting bracket all fit cleanly within
the round holes in the chassis rear wall
2).
1. Holes in the chassis
8.
Ensure that the hydraulic tank is level.
9.
Using C-clamps, or similar devices, temporarily
clamp the hydraulic tank firmly in place on the
chassis rear wall.
10.
Ensure that the hydraulic tank is still level.
11.
Mark the position of the hydraulic tank mounting
holes onto the chassis rear wall.
12.
Unclamp and remove the hydraulic tank.
13.
Center punch the position of the marked holes.
14.
Drill a 7/16 inch diameter hole through the
chassis rear wall in each marked and punched
position.
15.
De-burr each hole.
Figure 1
Figure 2
g013856
(Figure
g013857
Advertisement
Table of Contents
