Panasonic CZ-64ESMC3 Installation Instructions Manual page 12

Wiring
Before connecting wiring, be sure to turn the circuit breaker off. After all wiring
arrangements are complete, turn the circuit breaker on.
If the power supply wiring is mistakenly connected to a terminal board other than the
power supply terminal board, the devices to be connected to this controller or this
controller will malfunction. After connecting wiring, confi rm that the power supply wiring
is properly connected.
How to attach the ring pressure terminal
For power supply wiring
• Process the end of each wiring
and attach the ring pressure
terminal (fi eld supplied item).
For shield wiring
• Process the end of the each
wiring and attach the ring
pressure terminal (fi eld supplied
item).
Attention
Ground the shield on both sides of shield wiring, ohterwise an operation error from
noise may occur.
12
(EN)
(continued)
Ground
Strip
Remove wiring coat.
Cover with the tape.
Attach ring pressure
terminal.
Shield wiring
Ring
pressure
terminal
Shield mesh
Strip
Insulation
tape
Ground
Shield
mesh