Steps
1. Align the screw hole on the SATA FFC module with the screw hole on the system board.
2. Replace the single screw (M3x5) that secures the SATA FFC module to the system board.
3. Connect the SATA FFC to the connector on the system board and close the latch.
Next steps
1. Install the
hard
drive.
2. Install the
processor
fan.
3. Install the
side
cover.
4. Follow the procedure in
Processor
Removing the processor
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
processor
4. Remove the
heat
sink.
About this task
The following image(s) indicate the location of the processor and provide a visual representation of the removal procedure.
after working inside your
before working inside your
fan.
computer.
computer.
Removing and installing components
55