Service; Clean Out The Airways; Clean The Filters; Service Interval - Miele PDR 914 Operating And Installation Instructions

Changing this setting leads to increased energy consumption.
The setting can be changed from 104-131°F (40°C–55°C).
Factory default: 131°F (55°C)

Service

Clean out the airways

The tumble dryer's electronic calculates the degree at which lint or detergent residue in
the lint filters and air ducts are impairing performance. A message to check the contami-
nation appears. You can decide at what level of lint this reminder should be emitted.
This reminder, which you can configure, is displayed:
Off
-
The reminder does not appear. However, if there is a very severe blockage in the ducting,
the program will be canceled and the reminder will appear in the display regardless of
this option.
Heavy
-
The reminder only appears when there is a heavy build-up of lint.
- Factory default: Normal
Light
-
The reminder appears when there is only a small build-up of lint.

Clean the filters

The lint filter in the air-supply area must be cleaned on a regular basis. You can set an
hourly interval for the reminder.
The selected hourly interval depends on how much lint tends to build up and how often
you wish to clean the filter, e.g., for hygiene purposes.
You can adjust this reminder:
- Time interval of 5 – 55 hours
- Factory default: after 55 hours
- Off

Service interval

The tumble dryer shows a custom message at a selected interval to prompt you to under-
take specific maintenance tasks.
3 different messages can be created: 1/2/3. Each message is created in the language and
alphabet of the current supervisor language.
Your message is displayed at the end of the program and can be acknowledged with
The same message appears at the end of the next program.
Settings
This setting allows you to determine the interval (by hours or date) at which the message
appears.
- Factory default: Off
Clean the filters
Supervisor level
Clean out the airways
OK
.
45