Mitsubishi Electric OUTLANDER PHEV Dismantling Manual page 15

Procedure 3
Remove Service Plug
*Please use the check sheet on page 34.
The voltage of the smooth condenser in the MCU must be discharged thoroughly.
Wait 5 minutes after disconnecting negative terminal of 12V battery before
removing the service plug.
Wear protective electric insulation gloves when removing the service plug.
① Lift the service plug lever and then, pull the service plug.
② Remove the service plug.
Remove the service plug completely as current is being supplied by the main drive
lithium-ion battery during this procedure. Failure to remove the plug completely or use
of personal protective equipment could lead to serious injury or death.
After removing the service plug, keep it in a secure place away from other dismantlers
or technicians to prevent accidental handling/improper reinstallation.
Lever lock
13