Mitsubishi Electric OUTLANDER PHEV Dismantling Manual page 13

9. MAIN DRIVE LITHIUM-ION BATTERY REMOVAL PROCEDURE
● Wear electric insulation "personal protective equipment" such as gloves etc.,
when removing the service plug or when working on high voltage
components.
● Do not disassemble any component of the main drive lithium-ion battery other
than those described in this manual.
Before starting procedures
Discharge Refrigerant from Battery Cooling Unit (HVAC)
Procedure 1
Removing Service Lid Cover
*Please use the check sheet on page 34.
① Turn off the power supply mode of the electric motor
Wait two minutes after turning off power switch
before proceeding.
Rear bumper
② Disconnect the negative terminal of the auxiliary battery.
Rear hatch lock will be disabled once the 12V
negative battery terminal is disconnected.
Rear bumper
Negative terminal
for 12V battery
11
Wait two minutes!
Cover