Table of Contents
Advertisement
No.
Port
Power port
9
SDI port
10
VISCA IN port
11
VISCA OUT
12
port
HDMI OUT
13
port
HD-VI port
14
Network port
15
Installation
The VPC800 can be mounted on top of a display (such as TV set and monitor), wall-mounted,
ceiling-mounted, or placed horizontally, which you can select based on the site requirements.
If the display is thicker than 170 mm or the display is wall-mounted, the VPC800 can be
installed in any possible way other than be mounted on top of the display.
If the display is 170 mm or thinner, the VPC800 can be mounted on top of a display or placed
horizontally.
Placed Horizontally
Description
videoconferencing endpoints.
Functions as a 12 V DC power input port.
Functions as a bayonet-neill-concelman (BNC) connector to
output 3G-SDI and HD-SDI signals.
3G = 3rd Generation
HD = high definition
SDI = serial digital interface
Functions as a serial port to connect to an HD videoconferencing
endpoint or cascades with an upper-level camera. In addition, this
port can be used to upgrade the camera.
Cascades with a lower-level camera. This port complies with the
Video System Control Architecture (VISCA) standard.
VISCA is a trademark of Sony Corporation.
Outputs HDMI 2.0 signals and supports a resolution of up to 4K
x 2K 60 fps.
Inputs serial control signals, infrared signals, and 12 V power.
Outputs digital visual interface (DVI) or YPbPr video signals.
Used to upgrade the VPC800 or for Telnet operations, such as
pan/tilt the VPC800 and zoom it in/out.
Place the camera on a flat surface.
If you have to place the camera on a sloping surface,
ensure that the slope is less than 15° or the camera may not
function properly.
3
Advertisement
Table of Contents
