Charging The Battery; Product Overview - Toro TimeMaster 20199 Operator's Manual

1. The oil level is too low;
add oil to the crankcase.
2. The oil level is too high;
remove oil from the
crankcase.
•
If the oil level is too low, slowly pour a small
amount of oil into the oil-fill tube, wait 3 minutes,
and repeat steps 3 through 5 until the oil level on
the dipstick is correct as shown in Figure 7.
•
If the oil level is too high, drain the excess
oil until you obtain the correct oil level on
the dipstick. To drain the excess oil, refer to
Changing the Engine Oil (page 16).
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
6. Install the dipstick securely.
Important: Change the engine oil after the first 5
operating hours ; change it yearly thereafter. Refer
to Changing the Engine Oil (page 16).
4

Charging the Battery

No Parts Required
Procedure
Electric-start model only
Refer to Charging the Battery (page 17).
Figure 7
3. The oil level is correct.

Product Overview

4
3
2
1
g016439
1. Side-discharge deflector
2. Spark plug
3. Oil fill/dipstick (not shown) 11. Rear cutting-height lever
4. Recoil-start handle
5. Fuel-tank cap
6. Handle-lock lever
7. Handle knob (2)
8. Upper handle
7
8
7
6
5
10
11
12
13
14
15
16
Figure 8
9. Ignition switch
(electric-start model only)
or toggle switch (standard
model only)
10. Battery (electric-start
model only; not shown)
12. Rear-discharge deflector
13. Fuse
14. Air filter
15. Washout port
16. Front cutting-height lever
9