Replacing Batteries In The Remote Control; Replacing The Rechargeable Battery - Miele HS18 Operating Instructions Manual

 Place the robot vacuum cleaner
upside down on a level, clean
surface.
 Clean the sensors carefully using a
dry cotton wool bud.
Replacing batteries in the remote
control
The remote control requires two 1.5 V
(AAA) batteries.
 Remove the battery compartment
cover.
 Replace the batteries. Take care with
the polarity.
 Close the battery compartment cover.
 Observe the special instructions
regarding the handling and disposal
of batteries found in the sections
„Warning and Safety" and „Caring for
the environment" at the beginning of
these operating instructions.

Replacing the rechargeable battery

You will require an original Miele lithium-
ion rechargeable battery:
– YCR-M05 for Scout RX2

Do not use non-rechargeable
batteries.
28
The rechargeable battery compartment
is located in the robot vacuum cleaner's
storage compartment.
 Remove the dust box.
 Open the rechargeable battery
compartment by unlatching the cover
upwards.
Scout RX2 (YCR-M05)
 Carefully pull the cables so that the
plug connection is pulled out of the
slot.
 Press the latch on the plug
connection in order to release the
plug.
 Remove the rechargeable battery.
 Insert the plug of the new
rechargeable battery into the
counterpart, making sure it clicks into
place.
 Insert the rechargeable battery
carefully, making sure it is properly
positioned (see right-hand side of
picture).