Rt510Tx Thermostat Pairing With The Receiver - Salus RT510RF Full User Manual

8. RT510TX thermostat pairing with the receiver

The word PAIRING in the user settings means the function of synchronizing the transmitter with the receiver again, if it has been removed.
WARNING!
IN THE SET RT510RF THE THERMOSTAT IS FACTORY PAIRED WITH THE RECEIVER!
In order to pair the devices correctly, you must first prepare the receiver for synchronization!
1
If you want to re-pair the devices with
each other, make sure that the receiver
is disconnected from the power supply
and the switches on it are in the AUTO
and ON positions. Then connect the
receiver to the power supply and wait
for the red diode to glow continuously.
4
SELECT
Press and hold TEST / PAIRING
button for 3 seconds.
7
SELECT
Press and hold TEST / PAIRING
button for 3 seconds to end pairing
process.
2
5
SET TEST / PAIRING
3 sec
Thermostat started pairing process.
8
SET TEST / PAIRING
3 sec
main screen and it has been paired
Move the top switch to the OFF
position with a quick motion and
back to the ON position.
SELECT SET TEST / PAIRING
It can take up to 10 minutes.
TEST / PAIRING
SELECT SET
Thermostat will go back to the
successfully.
3
The red LED will start blinking, which
will confirm that the receiver has
entered the pairing mode.
6
When the red diode on the receiver
lights up continuously, the devices
have been paired on a new frequency.
21