Cleaning Of Vacuum / Saliva Ejector Handpiece - Belmont tbCompass Operating Instructions Manual

3
Cuspidor Unit Section
Vacuum Tip
Vacuum Cap
Slide Knob
Vacuum
Handpiece
Body
Hose
Connector
Vacuum Hose
Vacuum handpiece and saliva ejector handpiece
Cleaning of hole and sliding part
Cleaning the area
(brush is unable to reach)
• Cleaning must be done within 1 hour after use.
Replace with a new vacuum handpiece and saliva ejector handpiece for following cases.
• Any waste material can not be removed by clogged hole.
• Contamination and solid material attached to vacuum handpiece and saliva ejector can not be removed.
CARE AND MAINTENANCE
Handpiece
• For effective sterilization, washing for removing
contamination and immersion by a cleaning agent are
required. Then, rinse by water in order to remove residual
cleaning agent on medical device.
Upper Saliva
Take following procedures from cleaning to sterilization.
Ejector Cap
* Use the disposable saliva ejector tip.
Lower Saliva
Ejector Cap
[Disassembly]
Disassemble the handpiece for the preparation of cleaning as
Slide Knob
the following gures show.
Pull the hose connector to disconnect the vacuum hose.
Saliva Ejector
Handpiece
Body
Hose
Connector
Saliva Ejector
[Cleaning by hand]
Hose
1.Wipe off the surface contamination by a cloth while
2. Check whether contamination is removed or not after
3. Immersed with an alkaline disinfection or detergent
Cloth
4. Rinse thoroughly by distilled water at ordinary
CAUTION
58
Cleaning of Vacuum Handpiece / Saliva Ejector
rinsing the surface by running clean warm water at 40±5
degrees. Scrub the intubation or hole, slide groove and
clean warm water at 40±5 degrees. Wipe off by a cloth for
the area which brush is unable to reach.
cleaning. Continue the cleaning if contamination is
remained.
for 5 minutes.
(We recommend to use ID212 made by DURR)
temperature or by clean water for more than 1 minute.