Advertisement
5.
Tie the cable to the cable management bar far enough from the connector to allow for the manufacturer's recommended bend
radius. The bend radius for AMX SC terminated fiber cables is 2 inches (5 cm).
32x32 size enclosures only – Replace the connector numbering plate that was removed in Step 1.
6.
Technical Support
If this Technical Support Guide has not satisfactorily answered your questions regarding installing cable bars or the system is not
operating as expected, please contact your AMX representative or technical support. Have the product's serial number ready (it is
normally located on the rear of the enclosure).
We recommend recording the product's serial number in an easily accessible location.
AMX Technical Support Contact Number: +1 844 776 4899
© 2021 Harman. All rights reserved. SmartScale, NetLinx, Enova, AMX, AV FOR AN IT WORLD, and HARMAN, and their respective logos are
registered trademarks of HARMAN. Oracle, Java and any other company or brand name referenced may be trademarks/registered trademarks of
their respective companies.
AMX does not assume responsibility for errors or omissions. AMX also reserves the right to alter specifications without prior notice at any time.
The AMX Warranty and Return Policy and related documents can be viewed/downloaded at www.amx.com.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 AMX.com | 800.222.0193 | 469.624.8000 | +1.469.624.7400 | fax 469.624.7153
93-1056-054 REV: G
Last Revised: 2021-05-13
Advertisement
