Toro Groundsmaster 3320 Installation Instructions Manual page 6

Mount the Control Valve
1. Remove the seat and the seat base from the machine.
2. Loosen the fuel tank mounting fasteners so the fuel tank
can be elevated enough to gain access to the right
fender.
3. Locate the (3) holes in the right fender.
• If the rear hole is located 3.74 inches from the edge
of the fender as shown in figure 1, proceed to to
step 4.
1
3.74
Figure 1
1. Right fender
• If the rear hole is located 2.74 inches from the edge
of the fender as shown in figure 2, the holes must be
relocated. Use the dimensions in figure 3 to locate,
mark and drill (3) .344 in. dia. holes in the fender.
1
2.74
Figure 2
1. Right fender 2.
3.50
2.25
3.74
Figure 3
4. Mount the control valve and the pivot lever to the right
fender with (3) 1/4–20 x 2–3/4" lg. capscrews and
1/4–20 flange locknuts as shown in figure 4.
4
6
1
Figure 4
1. Control valve
2. Lift valve
3. Steering hose
4. Pivot lever
5. Place a drain pan under the lift valve (Fig. 4).
6. Disconnect the steering hose (Fig. 4), from the "P" port
(upper rear port) of the lift valve (hose comes from the
steering valve).
6
1.25
.344" dia. (3)
5
3
2
5. 90_ fitting (operator side
of valve)
6. 90_ fitting (outer side of
valve)