ABB GE ReliaGear Lighting Panelboard Instructions For Mounting

For screw cover fronts (with 5" front extension)

Download this manual

ReliaGear

Lighting Panelboards

For Screw Cover Fronts (with 5" front extension)

Screw-on Fronts

Front Attached Directly to Box

1. Push speed nuts over box flange holes as shown with nut side

of clip inside of box.

2. Attach front to box with 1" long trim screws provided.

Front

Trim Screws

Speed Nuts

Screw-on Fronts with 5" Extensions

Front Mounted with 5" Front Gutter Extension

1. Push speed nuts over box flange holes.

2. Push speed nuts over flange holes on both extensions

(left side and right side) with nut side of clips toward the

inside of the box.

3. Attach front to each extension with 1" long screws. Attach

front with extensions to box with 1" long trim screws.

Front Extensions

(Mounted Right Side)

Box

Front

Trim Screws

Speed Nuts

30" Wide Box Only

Need help?

Do you have a question about the GE ReliaGear Lighting Panelboard and is the answer not in the manual?

Page 1 ReliaGear Lighting Panelboards ® For Screw Cover Fronts (with 5" front extension) Screw-on Fronts Screw-on Fronts with 5" Extensions Front Attached Directly to Box Front Mounted with 5" Front Gutter Extension 1. Push speed nuts over box flange holes as shown with nut side 1.
Page 2 ©Copyright 2020 ABB. All rights reserved. 305 Gregson Drive Information provided is subject to change without notice. Please verify all details with ABB. All values are design or typical Cary, NC 27511 values when measured under laboratory conditions, and ABB makes no warranty or guarantee, express or implied, that such performance will be obtained under end-use conditions.