Fujitsu ScanSnap FI-5110C Operator's Manual page 14

CONTENTS CONTENTS
INTRODUCTION
Regulatory Information
Trademarks
Note, Liability
Preface
Safety Precautions
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATIONS
3 SCANNING VARIOUS TYPES OF
DOCUMENTS
4 DAILY CARE
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
7 DOCUMENT SPECIFICATIONS FOR ADF
8 OPTIONS
9 SCANNER SPECIFICATIONS
Appendix
Safety Precautions(3)
CAUTION
The following are the important cautions described in this manual.
Do not install the scanner on unstable surfaces.
Make sure that the scanner is installed on a flat, level surface and that none of
its parts extend beyond the surface top, such as a desk or table. Do not install
the scanner on unstable surfaces. Install the scanner on a level surface that is
free of vibration to prevent it from falling.
Install the scanner on a strong surface that will support the weight of the scanner
and other devices.
Do not block the ventilation ports.
Do not block the ventilation ports. Blocking the ventilation ports generates heat
inside of scanner, which may result in fire or scanner failure.
Do not place heavy objects or stand on top of the scanner.
Do not place heavy objects on the scanner or use the scanner's surface top to
perform other work. Improper installation might cause injuries and equipment
failure.
Firmly insert the power plug.
Firmly insert the power plug as far it can go into the power outlet.
Avoid any contact when scanner is in use.
Avoid touching any scanner mechanism during scanning since this may cause
injuries.
Do not use the scanner immediately after moving it from a
cold place into a warm room.
Do not use the device immediately after moving it from a cold place into a warm
room. Condensation may occur, which might lead to scanning errors. Let the
device dry about one or two hours before you use it.
1 2 4
3
1 2 4
3