Table of Contents
Advertisement
Fault
Bag Failed To Open
Communication Fail - I/O Master
to Controller
Communication Fail - I/O Master
to I/O Node
Master I/O Communication Fail-
ure
Controller Disconnected
Palm Button Configuration Error
Package Eject Guard Removed
MAX-PRO Operator Manual
FAULT & ALERT MANAGEMENT
BAGGER FAULTS
Cause
The Bag Opened Sensor failed to
make as the Bag Open Fingers
were attempting to open the bag.
Communications between Controller
and I/O master have been interrupt-
ed.
Communications between I/O Mas-
ter and expected I/O node have
been interrupted
The controller is disconnected.
Machine is configured for a single
palm button, but second palm button
seen active.
Package Eject Sensor failed to read
guard.
4-2
Possible Solution (S)
This fault is usually the result of a
problem with the Pressure Bar Pass
-thru Adjustment or Bag Open Fin-
gers Adjustment. Also check that
the Sensor operates correctly.
Verify cables are connected and
tightened properly.
Verify cables are connected and
tightened properly.
Connect the controller.
Select Dual Palm Buttons in the
Factory Setup\Cycle Button.
1. Mount the Package Eject
Guard.
2. Adjust Sensor.
Original Printed in English
Advertisement
Table of Contents
